- This topic has 7 replies, 5 voices, and was last updated 5 months, 1 week ago by
.
-
Posts
-
I just purchased a clutch master cylinder for my `65 Cortez.
NAPA p/n P21000. Check this to see if yours is the same for your `68.
Best wishes…The P21000 might work, but I believe Raybestos MC36071 is the correct one. Ask for the MC from a 61-66 Ford F250.
The clutch master cylinder works great and is a direct replacement from NAPA.
Now i need a Brake master cylinder for my65 Cortez and cant find any info. for a replacement,
Please advise… Thx!Moose,
Do you have any idea where i can find a brake master cylinder for my `65 Cortez?
Thanks in advance, ClarkIn the info library there is a listing for a brake master cylinder that says Wagner F37073 TRH29. I have a replacement MC in my 64 that has a cap that sticks up so high that the cover won’t close over the dash opening. Any suggestions? I’m not sure what type mc it is, or if I should relieve the cap enough to get the cover latch to close. Could grind the plastic cap and then heat seal it so I don’t get leakage when fluid gets hot but would rather get the right part.
Clark, If you go onto Rock Auto (https://www.rockauto.com/en/catalog/ford,1964,f-250,3.6l+223cid+l6,1333831,brake+&+wheel+hub,master+cylinder,1836) you’ll find it under Ford f250 for the model years Moose mentioned. The Dynamic Friction looks to be the correct one…smaller cap, but its a crap shoot. Mine looks like the Centric with the large plastic cap that doesn’t allow the cover to close.
- You must be logged in to reply to this topic.