Skip to toolbar

Reply To: V8 Conversion Help??

Home Forums Discussion Forum V8 Conversion Help?? Reply To: V8 Conversion Help??

#673
Jess Bressi
Participant

Yes, I have the brackets to use as a model/mock up. They appear to be the same for both sides. They appear to be a forging but I’m not a fabrication expert. It may be possible to make them from two pieces of 1/2 place welded together with very high quality welding and then milled to shape or one about 1″ or so thick round that is milled and cut on a lathe to make four brackets at a time (each bracket is about 90 or less degrees of a circle. I wonder if there is anyone on this site with the knowledge of how to properly make these???

Jess Bressi, OC CA
1974 Side Bath/Rear Bedroom
19.5" Rims/front disc brakes/3.71 Final drive
Keep on Cortezz'n